RMC StiffBelts – Console Commands (v21 console pack)

All commands are runtime tunables for NON-split objects (vehicles, pallets). Logs/trees keep base straps.

Placement
  gsRMCObjDeckClearance [m]   - Min gap above deck for object-side anchor. Default 0.04 (0.03–0.06 good).
  gsRMCObjHeightBias [m]      - Fine offset added to target height (negative lowers). Default 0.00 (±0.02).
  gsRMCObjAnchorSpread [m]    - Scales X/Z of the three anchor offsets (triangle width). Default 0.22.
  gsRMCObjClampDownOnly 0|1   - 1=only lower anchors toward target (default). 0=force anchors to target (up or down).

Mass & Inertia (NON-split only; restored on unstrap)
  gsRMCObjMassScale [0.10..3.00] - Temporarily scale object mass while strapped. Default 1.00.
  gsRMCObjInertiaScale sx sy sz  - Temporarily scale inertia while strapped. Default 1 1 1.

Joint Strategy
  gsRMCMaxJointCount [1..3]   - Maximum number of joints per strapped object (triangle=3). Default 3.
  gsRMCMinMassForTri [kg]     - If MAX=3 and object mass is below this value, use <=2 joints. Default 250 kg.

Presets
  gsRMCPreset TightLock       - Low clearance, slight negative bias, wider spread, 3 joints, mild mass/inertia scale.
  gsRMCPreset SmoothHaul      - Balanced defaults.
  gsRMCPreset LightCargo      - Narrow spread, 2 joints, higher min mass for triangle.

Notes
- Commands are registered once when a vehicle with this specialization loads.
- Changes apply to NEW straps (re-strap to feel differences).
- Logs/trees are not affected by these settings; they use base-game tension belts.
